G03711075
7-9-07
Page 6 of 11
6
- ALL DOORS
Place the setting blocks [H] into the curb [A]
as shown to support the fixed glass panels [J].
Locate the setting blocks 3" from the corners of the
glass panels. Set the first glass panel into place on
the setting blocks and approximately 1/2" into the
wall jamb [E]. A strip of masking tape 1/2" from
each vertical edge of the glass will aid alignment.
NOTE: Obscure glass panels should be installed
with the rough surface of the glass to the exterior
of the unit. Deco or etched glass panels should
have the patterned surface to the inside.
Press the 90° post [K] into the curb assembly. It
should overlap the glass panel by 1/2". Use masking
tape to hold the post in position temporarily. Set
the second glass panel into place, then press the
180° post [L] into the curb and secure with tape.
Press the header assembly [D] over the wall
jambs [E], 90° post [K] and the 180° post [L].
Check the posts for plumb. Adjust as required by
varying the overlap of the header over the wall
jambs. You may need to trim the ends of the
header where it meets the wall. The minimum
horizontal dimension for the door opening is the
door panel width (see the graphic in Step #9) plus
3/4", maximum is the door panel width plus 1 3/4".
Using the holes in the ends of the header and curb
as a guide, drill four 1/8" holes into the wall jambs.
Drill four 1/8" holes thru the header and curb into
the two posts as shown, then enlarge the four
outer holes with a 3/16" drill for clearance on the
self-tapping screws. Secure the header and curb
to the wall jambs and posts with eight #8 x 1/4"
truss head screws [C].
CAUTION: Slide the glass panels away from the
jamb or post before drilling to prevent breakage.
8
- ALL DOORS
7
- ALL DOORS
Hold the 90° post [K] plumb and carefully
measure horizontally from the top of each wall
jamb [E] to the outside edge of the post. Add 3/16"
to each measurement to find the corresponding
dimension on the header assembly [D] (from the
outside mitered edge to the squared ends) and
trim the header assembly to fit.
NOTE: To facilitate out of plumb walls, the 1/2"
glass bite may be varied from 1/4" to 3/4".
Using a 3/16" drill bit, drill the interior face of the
header assembly on both ends as shown.
(1 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels