Alumax 793 Manuel d'utilisateur Page 8

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 12
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 7
Page 7 of 11 G03711075
7-9-07
9
- 790 DOORS ONLY
Strip two clear vinyl jamb seals [M] into the
door panel [N] splash guard and the pivot jamb [P]
and trim flush at the ends. Both vinyls should be
turned to trap water from the shower head. Secure
the vinyls with a small quantity of glue or caulk at
each end or by carefully crimping the vinyl pocket.
Set the door panel aside.
Press the pivot jamb and strike jamb [R] (with
magnetic strip) over the wall jamb [E] and 180°
post [L]. Refer to Step #1 for the proper handing
of the door.
NOTE: The magnetic strip on the strike jamb
must face the exterior and the clear vinyl jamb
seal on the pivot jamb must face inward.
10
- 790 DOORS ONLY
Snap the fillers [S] into the curb assembly
[A] and header assembly [D] between the door
jambs with the raised lip to the exterior and the
pivot holes toward the pivot jamb. Center the curb
filler in the curb between the pivot and strike
jamb (use masking tape to hold in position).
NOTE: The snap-in fillers should be exactly 3/8"
longer than the door panel width.
11
- 790 DOORS ONLY
Pull the bottom end of the pivot jamb [P]
tight to the curb filler [S] and plumb the jamb.
Drill two 1/8" holes thru the pivot jamb and into
the wall jamb [E] 3/8" to 3/4" from the wall and
approximately 1/4" vertically from the ends of the
jamb. Drill a third hole centered between the first
two and enlarge the outer holes with a 3/16" drill
for clearance on the self-tapping screws. Attach
the pivot jamb permanently with three #8 x 1/4"
truss head screws [C].
Slide the header filler [S] tight against the pivot
jamb. Push the strike jamb [R] tight against the
fillers top and bottom. With the pivot jamb plumb
and both fillers tight between the two door jambs,
the strike jamb also will be plumb and parallel to
the pivot jamb. Attach the strike jamb to the 180°
post [L] in the same manner as the pivot jamb.
Vue de la page 7
1 2 3 4 5 6 7 8 9 10 11 12

Commentaires sur ces manuels

Pas de commentaire