Alumax 793 Manuel d'utilisateur télécharger pdf (Page 10)

Page 9 of 11 G03711075

7-9-07

- 790 DOORS ONLY

Inspect the pieces of black glazing vinyl, and

note the two different profiles. The smaller shape

[GG] is installed vertically and the larger shape

[HH] is installed horizontally. For structural

strength and maximum water resistance, these

vinyls are designed to fit tightly between the glass

and framing. To speed installation, use glass cleaner

for lubrication and a small block of wood to press the

vinyl into place.

- ALL DOORS

- 790 DOORS ONLY

Attach the interior door handle [DD] and

the exterior door handle [EE] to the door panel [N]

with two #6-32 x 1 1/4" round head screws [FF].

Close the door and check the clearance with the

strike jamb [R]. If necessary, loosen the set

screws [Y] on the top and bottom slide bars and

adjust the door panel to align the strike magnets.

When the door panel is properly aligned, tighten

the set screws securely.

Adjust the drip vinyl [V] by sliding it left or

right until it just touches the curb. Trim the vinyl

(flush with the pivot end and notch 1/4" longer

than the drip rail as shown on the strike end).

The drip plug [U] is supplied with a left and right

hand plug together. Break the right and left drip

plug apart and insert the appropriate plug into

the high (strike) side of the drip rail. Discard the

unused drip plug. Peel off the tape backing and

carefully press the drip rail [T] to the door in the

marked position.

1/4" GLASS

REQUIRES:

V-219

V-220

3/16" GLASS

REQUIRES:

V-226 V-225

1 2 ... 5 6 7 8 9 10 11 12

Pas de commentaire

Alumax 793 Manuel d'utilisateur Page 10