Alumax 392 Manuel d'utilisateur télécharger pdf (Page 6)

EPH-N00-06010

5-20-97

Page 6 of 11

Hold the 90° post [K] plumb and carefully

measure horizontally from the top of each wall

jamb [E] to the outside edge of the post. Add 3/16"

to each measurement to find the corresponding

dimension on the header assembly [D] (from the

outside mitered edge to the squared ends) and

trim the header assembly to fit.

Using a 3/16" drill bit, drill the interior face of the

header assembly on both ends as shown.

Press the header assembly [D] over the wall

jambs [E] and the 90° post [K]. Check the post for

plumb. Adjust as required by varying the overlap of the

header over the wall jambs. In some cases, you may

need to trim the ends of the header where it meets the

wall. The minimum horizontal dimension for the door

opening is the door panel width (see the graphic in Step

#9) plus 1/2", maximum is the door panel width plus 1

3/4".

Use the holes in the ends of the header and curb as a

guide and drill four 1/8" holes into the wall jambs. Drill

two holes thru the header and curb into the 90° post as

shown, then enlarge the two outer holes with a 3/16"

drill for clearance on the self-tapping screws. Secure

the header and curb to the wall jambs and post with six

#8 x 1/4" truss head screws [C].

CAUTION: Slide the glass panel away from the wall

jamb before drilling to prevent breakage.

Slide the clear vinyl pivot jamb seal [L] into

the pivot jamb [M] and trim flush at both ends.

The vinyl should be turned to trap water from the

shower head. Secure the vinyl with a small quan-

tity of glue or caulk at each end or by carefully

crimping the vinyl pocket.

Press the pivot jamb and the strike jamb assembly

[N] (with magnetic strip) over the wall jamb [E]

and 90° post [K]. Refer to Step #1 for the proper

handing of the door.

NOTE: The magnetic strip on the strike jamb

must face the exterior and the clear vinyl jamb

seal on the pivot jamb must face inward.

1 2 3 4 5 6 7 8 9 10 11

Commentaires sur ces manuels

Pas de commentaire

Alumax 392 Manuel d'utilisateur Page 6

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la maison Alumax 392