Alumax 392 Manuel d'utilisateur télécharger pdf (Page 4)

EPH-N00-06010

5-20-97

Page 4 of 11

The ALUMAX 392 STIKSTALL Shower Enclo-

sure is completely reversible and may be installed

pivot-left or pivot-right. The door may pivot from

the wall or from the center post. Using the illus-

tration, determine the correct position for the door

in your particular STIKSTALL installation. This

instruction sheet depicts a pivot-right installa-

tion.

NOTE: Fixed glass panel size should be deter-

mined by formulas shown on A

LUMAX detail sheets.

CAUTION: For safety reasons, the door panel

must always open outward.

Assemble the two curb sections [A] (with

weep slots) by sliding a 90° anchor plate [B] into

the mitered ends and forcing the sections together.

The weep slots in the curb must be to the inside.

Using the slotted holes in the anchor plate as a

guide, drill matching 1/8" holes into the curbs.

Secure the anchor plate to the curb with four #8 x

1/4" truss head screws [C]. As you tighten the

screws, be sure the mitered ends are forced tightly

together. To increase the rigidity of the mitered

joint, drill and install two more screws through

the round holes in the bracket.

Assemble the two header sections [D] in the same

manner and set the header assembly aside.

Measure the opening at the bottom of the

shower stall and trim the ends of the curb assem-

bly [A] (with weep slots) to fit the shower sill. The

curb should sit near the centerline of the sill. If

required, use a file to round the lower ends of the

curb assembly to fit the shower sill properly.

Using a 3/16" drill bit, drill the interior face of the

curb assembly on both ends as shown.

Reposition the curb assembly on the shower sill

and mark its position with a pencil line along the

interior and exterior base.

1 2 3 4 5 6 7 8 9 10 11

Pas de commentaire

Alumax 392 Manuel d'utilisateur Page 4